Pipe Wrap from Mathey Dearman is an excellent easy to use accessory for pipe fitters and welders. It has double-ruled edge so it is never upside down or backwards. The Wrap can be used as a straight edge to mark straight lines around the pipe and to mark angles for pipe elbows. This pipe marking ruler is constructed of highly abrasion and solvent resistant materials to last under heavy use.
- Table of tangents and straight edge
- Instructions for cutting elbows
- Sides marked in 1/8” (3.2 mm) increments to 36” (914 mm)
- Instructions for finding the length of an elbow
- 45-degree angle chart
- Degree markings
The wrap is available in widths of 4″, 5″ and 7″.
For larger pipes we can supply any lengths as required in inch increments.
To determine the required length multiply the pipe diameter x 3.14 = pipe circumference. Add a few inches to this number to determine length required.
D160 – suitable for Pipe size 3″-15″. 4″ x 4′
D170 – suitable for Pipe size 3″-22″. 4″ x 6′
D177 – suitable for Pipe size 3″-22″. 4″ x 7′
D184 – 4″ Width x Length Desired Sold in 1′ Increments
D185 – 5″ Width x Length Desired Sold in 1′ Increments
D187 – 7″ Width x Length Desired Sold in 1′ Increments
More details available at Mathey Dearman
The Pipe Wrap is an excellent tool for aligning MagnaCut XM and CGM Guide Tracks on pipe over 18″ (457 mm) to insure a square cut.
We offer you a host of pipe fit-up tools and accessories to make your job easier.
We offer Internal and external pipe alignment clamps, weld Gages from GAL-Gage, Spacing Wedges, Flange spreaders, Flange Line-Up pins and much more…
Please visit our category page for pipe fit-up tools Pipe Fit-Up tools or call us to discss your specific requirement.